![]() ![]() You should change those defaults ASAP, of course, for security reasons. Log into the the web administration page by visiting with the default username:password of admin:admin. ![]() ![]() Since the default IP address for the switch is 192.168.0.1, you should set your IP address within the same subnet (192.168.0.2 - 192.168.0.254) so that you may access the web administration for the switch. The switch does not have DHCP enabled by default so you will need to manually enter your IP address in your computer. The switch does not need to be plugged into other network device such as a router until the initial configuration is completed. To begin configuring the switch, first plug a desktop or laptop computer into any port in the switch. I am assuming the switch is currently configured with the default settings from the factory. To show the difference between the firmware versions. Click on Save/Apply to save the changes.In this how-to, I will using the TP-Link T2600G-28TS L2 managed switch (affiliate link)Īnd the TP-Link T1500G-10MPS PoE smart switch (affiliate link).There, enter your old password and then enter your new password & re-enter it again for verification.Once logged in, go to Management->Access Control->Password.To avoid all this, here is how you can change your TP-Link Login Password: Your Admin Panel holds the key to all the settings of your router and it is important that you change the login password of your Admin Panel, otherwise, anyone connected to your network can change the login password and mess up the settings of your Router and you will have to reset your router to factory defaults. How to change the TP-Link Login password? Now, click on Save to save the changes and reboot your router.(8-63 characters, including alphabets, digits, and special symbols) In the PSK Password field, type your new Wi-FI Password.Scroll down to the WPA-PSK/WPA2-PSK section.Once logged in, go to Wireless -> Wireless Security.Log in to the Admin Panel of your TP-Link Router.Here is how you can change the password of your TP-Link WiFi network: So you should change the password of your WiFi network to keep it secure. How to change the password of the TP-Link WiFi Network?Ĭhanging the password of the TP-Link WiFi network is important because any new router that you buy uses the default credentials for your WiFi including default WiFi SSID and Password. From there you can change different settings of your router including the password of your WiFi network and also the password of your Router Login. If the login details are correct, you will be logged into the TP-Link Admin interface.You can find the default TP-Link login username and password on a label at the side or underneath the TP-Link Router. In case you have changed the login password then enter as configured. Enter admin for username and password for password.Once the login page appears, you will be asked to enter the login credentials.Once connected, open a web browser and in the address bar, type or you can use the Router’s IP address or to login instead of.The first thing is to connect your device to the TP-Link Network, either wirelessly using the WiFI network or using an Ethernet cable.Here is how you can log in to the TP-Link Router Admin Panel and change desired settings: A PC/Laptop/Mobile/Tablet connected to the TP-Link WiFi network.By logging to your TP-Link router settings page you will be able to change the password of your WiFi network and other settings such as SSID, LAN, and WAN Settings.īefore you can log in, you need to have the following: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |